A terrible terrible DIYer made a real mess of this installation.
I know this is nerdy stuff, but today I encountered the highest PSC (Prospective Short-Circuit Current) that I’ve ever encountered on an installation.
23kA was the figure I found, with an external loop impedance of just 0.01A
So, why you ask am I sharing this?
Let me briefly explain.
All breakers have a maximum “breaking capacity”. It’s a number, usually in a box, on the front of the device. Most domestic ones are 6kA, industrial tend to be 10, 12, 15 or even 25.
If a short circuit occurs which takes the fault current above the breaking capacity of the breaker then the breaker may not actually trip, or it might fail, or the it may trip but the spark will then “hop the gap”.
So, what do we do in this circumstance?
Well we could protect the installation with BS1361 fuses, however, that is not guaranteed to get your 0.4 second trip time.
My chosen method is to put an MCCB (Moulded case circuit breaker) with a 25kA breaking capacity into the meter tails. Not only do you then get your 0.4s trip time, but you get a guaranteed trip at high PSC’s.
Changed all 27 lights in this building. Every single one had to have the hole tidied up as the old holes were really badly cut and not round.
When a system is getting false alarms it’s always really irritating. Thankfully this place has CCTV so we searched through the system and found sunlight streaming through a shutter door to be the likely cause.
We’ll see over the coming days.
Today project Tidy Up really got kicked off. An old busbar system needs stripping and the building part rewiring (particularly the old IT system) so I thought I’d start at the disboard.
A lovely Schneider Acti9 fitted to replace a pair of old Crabtree C15 units, complete with RCBO’s where the circuits would take them.
Next week I strip out a load of rotary isolators connected to the busbars, with the eventual goal of totally losing everything on the ladder frame and shortening the box trunking.
I hate crimping these things. It’s so annoying when you think it’s all good and then you realise a pair of wires have jumped over each other.
Yesterday and today I’ve been doing general electrical work on our own house (yes… our own house). I’ve fitted 4 new power points (kitchen, living room x 4,in 2 places, landing) and have had to disconnect two lights in the house because the wiring is the old fashioned rubber cable and is in a pretty rough state.
I’ve also fitted a new radiator in the bedroom (replaced the old one because it was too small).
Christmas was very nice… we went to Hannah’s parents for Christmas Dinner and Boxing Day. I got Zelda – Spirit Tracks and Professor Layton – Pandora’s Box, as well as many other presents.
Now what to do… well eat pie and peas first of all cos they’ll be done soon!